RNA is a biopolymer of high relevance in the biopharmaceuticals field and in fundamental and applied research; however, the preservation of the RNA stability is still a remarkable challenge. Herein, we demonstrate the enhanced potential of aqueous solutions of self-buffering cholinium-based Good's buffers ionic liquids (GB-ILs), at 20 and 50 % (w/w), as alternative preservation media of recombinant small RNAs. The thermal stability of RNA is highly enhanced by GB-ILs, with an increase of 14 °C in the biopolymer melting temperature - the highest increase observed up to date with ILs. Most GB-ILs investigated improve the stability of RNA at least up to 30-days, both at 25 °C and at 4 °C, without requiring the typical samples freezing. Molecular dynamics simulations were applied to better understand the molecular-level mechanisms responsible for the observed RNA improved stability. The number of IL cations surrounding the RNA chain is similar, yet with differences found for the IL anions, which are responsible for the overall charge of the biopolymer first solvation sphere. No cytotoxicity of the studied solutions containing RNA and ILs at 20 % (w/w) was observed onto two distinct human cell lines, reinforcing their potential to act as preservation media when foreseeing biopharmaceutical applications. Finally, RNA was successfully recovered from the ILs aqueous solutions, without changes in its structural integrity, and the ILs successfully recycled and reused.

The limited efficiency of conventional drugs has been instigated the development of new and more effective drug delivery systems (DDS). Transdermal DDS, are associated with numerous advantages such its painless application and less frequent replacement and greater flexibility of dosing, features that triggered the research and development of such devices. Such systems have been produced using either biopolymer; or synthetic polymers. Although the first ones are safer, biocompatible and present a controlled degradation by human enzymes or water, the second ones are the most currently available in the market due to their greater mechanical resistance and flexibility, and non-degradation over time. This review highlights the most recent advances (mainly in the last five years) of patches aimed for transdermal drug delivery, focusing on the different materials (natural, synthetic and blends) and latest designs for the development of such devices, emphasizing also their combination with drug carriers that enable enhanced drug solubility and a more controlled release of the drug over the time. The benefits and limitations of different patches formulations are considered with reference to their appliance to transdermal drug delivery. Furthermore, a record of the currently available patches on the market is given, featuring their most relevant characteristics. Finally, a list of most recent/ongoing clinical trials regarding the use of patches for skin disorders is detailed and critical insights on the current state of patches for transdermal drug delivery are also provided.

Contributing to extending the knowledge for the design and operation of biodiesel production processes, isobaric PTxy vapor-liquid equilibria data of ethanol + ethyl hexanoate, 1-pentanol + ethyl hexanoate and 1-pentanol + ethyl octanoate at two different pressures are reported for the first time. Consistency tests were applied to attest the quality of the collected data, for these especially complex measurements. Besides that, vapor pressures of the pure ethyl esters have also been measured. For modeling purposes, the Lyngby and Dortmund UNIFAC variants were used to predict the VLE phase diagrams. Generally, the predictions are of very good quality, being the UNIFAC-Do (Dortmund) better, as the deviations in temperature and vapor compositions are always lower to 1.0 K and 0.020, respectively. Checking for the viability for extrapolations in pressure, CPA EoS was also applied to the modeling of the experimental data with very good results. Finally, aiming at examining the model capabilities to describe multicomponent systems, VLE measurements involving two alcohols and the fatty acid ethyl ester mixture obtained from non-edible vegetable oil have been carried out showing the good performance of the predictive models.

Sustainable hydrophobic eutectic solvents, composed of low-priced and biodegradable terpenes and fatty acids, were used for the extraction and separation of Cu(ii) from other transition metals in mildly acidic solutions. Multiple parameters were evaluated for metal extraction and the hydrophobic eutectic solvent was successfully recovered and reused.

Recently, some works claim that hydrophobic deep eutectic solvents could be prepared based on menthol and monocarboxylic acids. Despite of some promising potential applications, these systems were poorly understood, and this work addresses this issue. Here, the characterization of eutectic solvents composed of the terpenes thymol or l(-)-menthol and monocarboxylic acids is studied aiming the design of these solvents. Their solid-liquid phase diagrams were measured by differential scanning calorimetry in the whole composition range, showing that a broader composition range, and not only fixed stoichiometric proportions, can be used as solvents at low temperatures. Additionally, solvent densities and viscosities close to the eutectic compositions were measured, showing low viscosity and lower density than water. The solvatochromic parameters at the eutectic composition were also investigated aiming at better understanding their polarity. The high acidity is mainly provided by the presence of thymol in the mixture, while l(-)-menthol plays the major role on the hydrogen-bond basicity. The measured mutual solubilities with water attest to the hydrophobic character of the mixtures investigated. The experimental solid-liquid phase diagrams were described using the PC-SAFT equation of state that is shown to accurately describe the experimental data and quantify the small deviations from ideality.

The knowledge of critical properties is fundamental in engineering process calculations for the estimation of thermodynamic properties and phase equilibria. A literature survey shows a large number of methods for predicting critical properties of different classes of compounds, but no previous study is available to evaluate their suitability for terpenes and terpenoids. In this work, the critical properties of terpenes and terpenoids were first estimated using the group-contribution methods of Joback, Constantinou and Gani, and Wilson and Jasperson. These were then used to calculate densities and vapor pressure through the equations of state Peng-Robinson (PR) and Soave-Redlich-Kwong (SRK) and then compared with the experimental values. On other hand, density and vapor pressure experimental data were used to estimate the critical properties directly by the same equations of state (EoSs), allowing a comparison between the two estimation procedures. For this purpose densities for 17 pure terpenes and terpenoids were here measured at atmospheric pressure in the temperature range (278.15 to 368.15) K. Using the first approach, the best combination is the Joback's method with the Peng-Robinson EoS, despite the high relative deviations found for vapor pressure calculations and difficulties to predict density at low temperatures. Following the second approach, the set of critical properties and acentric factors estimated are able to adequately correlate the experimental data. Both equatio ns show a similar capability to correlate the data with SRK EoS presenting a global %ARD of 3.16 and 0.62 for vapor pressure and density, respectively; while the PR EoS presented 3.61 and 0.66, for the same properties, both giving critical properties estimates also closer to those calculated by the Joback method, which is the recommended group-contribution method for this type of compounds.

The solubilities of gallic, protocatechuic, gentisic or α-resorcylic acids were measured in nine pure solvents (water, methanol, ethanol, 1-propanol, 2-propanol, 2-butanone, ethyl acetate, acetonitrile and dimethylformamide) at 298.15 K and 313.15 K, using the analytical isothermal shake-flask method. Additionally, solid phase studies of the selected phenolic acids were carried out using differential scanning calorimetry (DSC) and X-ray diffraction (XRD), giving access to important data on melting properties as well as on the structure of the solid phase before and after the dissolution. The NRTL-SAC model coupled to the reference solvent approach (RSA) were applied to correlate the solubility data in a set of seven solvents and, after used to predict the solubility in 1-propanol and dimethylformamide. Average relative deviations (ARD) between 28 and 40% for the correlation and between 16 and 59% for the predictions were obtained. These values are within the order of magnitude usually found for such type of semi-predictive models, using a limited set of data.

The extraction of phenolic compounds from walnut leaves (Juglans regia L.) was optimized using heat-assisted extraction and deep eutectic solvents based on choline chloride and carboxylic acids. A preliminary solvent screening was performed using a selected group of carboxylic acids as hydrogen bond donors, showing that the highest extraction yield of phenolic compounds was obtained using choline chloride mixtures with butyric or phenylpropionic acid at a mole ratio 1:2, with 20% of water (w/w). The extraction conditions (time, temperature and water proportion) were then optimized by an experimental design, assisted by response surface methodology. To evaluate the response, the three most abundant compounds identified by HPLC (neochlorogenic acid, quercetin 3-O-glucoside and quercetin O-pentoside) were quantified. Additionally, the solid/liquid ratio effect at the optimal conditions, in dose-response format, was studied in view of its upscale, not showing any significant decrease until 140 g/L. The results here presented provide valuable information towards the design of a process in a pre-industrial form for the extraction of phenolic compounds from J. regia leaves using deep eutectic solvents.

Deep eutectic solvents (DES) present interesting properties, mostly connected to their solvation ability, and have been subject to much research in the recent past. Currently, the discovery of new eutectic solvents is accomplished by experimentally measuring the eutectic point of random systems, often using choline chloride as a hydrogen bond acceptor. In this work, the eutectic temperatures of new choline chloride-based eutectic systems were experimentally assessed. These data, along with other previously reported in the literature, were used to evaluate a method based on COSMO-RS to predict the eutectic temperature of choline-chloride based mixtures. The predictive methodology herein developed allows for the quick scanning of a large matrix of systems in order to identify those more promising to be in the liquid state at a given temperature. To validate this method, the eutectic temperature of pharmaceutical drug mixtures was predicted and, then, assessed experimentally, showing that COSMO-RS is useful in the design of liquid drug-based formulations.

In order to evaluate the impact of the alkyl side chain length and symmetry of the cation on the thermophysical properties of water-saturated ionic liquids (ILs), densities and viscosities as a function of temperature were measured at atmospheric pressure and in the (298.15 to 363.15) K temperature range, for systems containing two series of bis(trifluoromethylsulfonyl)imide-based compounds: the symmetric [C n C n im][NTf2] (with n = 1-8 and 10) and asymmetric [C n C1im][NTf2] (with n = 2-5, 7, 9 and 11) ILs. For water-saturated ILs, the density decreases with the increase of the alkyl side chain length while the viscosity increases with the size of the aliphatic tails. The saturation water solubility in each IL was further estimated with a reasonable agreement based on the densities of water-saturated ILs, further confirming that for the ILs investigated the volumetric mixing properties of ILs and water follow a near ideal behaviour. The water-saturated symmetric ILs generally present lower densities and viscosities than their asymmetric counterparts. From the experimental data, the isobaric thermal expansion coefficient and energy barrier were also estimated. A close correlation between the difference in the energy barrier values between the water-saturated and pure ILs and the water content in each IL was found, supporting that the decrease in the viscosity of ILs in presence of water is directly related with the decrease of the energy barrier.