The concept of piezoelectric energy production is based on energy-harvesting devices using generation materials such as single crystals, ceramics, polymers, and composites. These production systems can harvest wasted environmental energy and convert it essentially into electrical energy. There are different nano- and microscale power harvesters which are increasingly useful for powering mobile electronics and low-power devices, even in hardly accessible areas. Despite many efforts in the development of new materials, the most widely used materials in device applications remain the ceramics of the lead zirconate titanate family, since they still present the higher output performances in the range of milliwatts of generated power.

Energy harvesting from the environment based on electroactive polymers has been increasing in recent years. Ferroelectric polymers are used as mechanical-to-electrical energy transducers in a wide range of applications, scavenging the surrounding energy to power low-power devices. These energy-harvesting systems operate by taking advantage of the piezoelectric, pyroelectric, and magnetoelectric properties of the polymers, harvesting wasted environmental energy and converting it mainly into electrical energy. There have been developed different nano- and micro-scale power harvesters with an increasing interest for powering mobile electronics and low-power devices, including applications in remote access areas. Novel electronic devices are developed based on low-power solutions, and therefore, polymer-based materials represent a suitable solution to power these devices. Among the different polymers, the most widely used in the device application is the poly(vinylidene fluoride) (PVDF) family, due to its higher output performance.

This manuscript reports on the modification of the surface wettability of poly (vinylidene fluoride) (PVDF) and PVDF copolymer films and membranes by plasma treatments at different conditions, under oxygen and argon atmospheres. It is shown that a more pronounced decrease of the contact angle after O2 plasma treatments is obtained, with a decrease of ∼20-30° for PVDF and its copolymers films, leading also to superhydrophilic membranes. This effect is related to a defluorination process, followed by the incorporation of oxygen atoms onto the surface of membranes that occurs during the surface modification. The influence of plasma treatments on surface morphology and topography was studied by atomic force microscopy, showing a decrease in the mean surface roughness with the plasma treatments, being more noticeable for Ar treatments. Finally, it is also shown that plasma treatments under Ar and O2 did not induce modifications in the physicochemical and thermal properties of PVDF and PVDF copolymers. The chemical reaction mechanism after plasma treatment is proposed for the different copolymers.