To comply with the increase in luminosity of the LHC (Large Hadron Collider) in the next decades, the electronics of the ATLAS (A Toroidal LHC Apparatus) experiment is being upgraded. Included in the upgrade is the interfacing and control electronics system of the HVOpto/HVRemote cards in the TileCal (Tile Calorimeter) detector, which provides high voltages to about 104 photomultipliers (PMTs). This paper presents the new interfacing architecture for the system and details the design of a prototype control board (HVRemote-Ctrl) used for test and validation of the new architecture. The tests evaluate the system multiplexing capabilities needed to monitor all the TileCal PMTs in real time. The communication channels involved, supported in Ethernet and SPI interfaces/protocols, have been fully tested. Some results from the tests already completed are presented.

To comply with the increase in luminosity of the LHC (Large Hadron Collider) in the next decades, the electronics of the ATLAS (A Toroidal LHC Apparatus) experiment is being upgraded. Included in the upgrade is the interfacing and control electronics system of the HVOpto/HVRemote cards in the TileCal (Tile Calorimeter) detector, which provides high voltages to about 104 photomultipliers (PMTs). This paper presents the new interfacing architecture for the system and details the design of a prototype control board (HVRemote-Ctrl) used for test and validation of the new architecture. The tests evaluate the system multiplexing capabilities needed to monitor all the TileCal PMTs in real time. The communication channels involved, supported in Ethernet and SPI interfaces/protocols, have been fully tested. Some results from the tests already completed are presented.

One of the proposed solutions for upgrading the high voltage (HV) system of Tilecal, the ATLAS hadron calorimeter, consists in removing the HV regulation boards from the detector and deploying them in a low-radiation room where there is permanent access for maintenance. This option requires many ~100 m long HV cables but removes the requirement of radiation hard boards. That solution simplifies the control system of the HV regulation cards (called HVRemote). It consists of a Detector Control System (DCS) node linked to 256 HVRemote boards through a tree of Ethernet connections. Each HVRemote includes a smart Ethernet transceiver for converting data and commands from the DCS into serial peripheral interface (SPI) signals routed to SPI-capable devices in the HVRemote. The DCS connection to the transceiver and the control of some SPI-capable devices via Ethernet has been tested successfully. A test board (HVRemote-ctrl) with the interfacing sub-system of the HVRemote was fabricated. It is being tested through SPI-interfaces and several devices were already validated. A next version adds a few more ADC/DAC devices for checking their suitability for the final design.